Product Details
Restockable Yes
Warranty 1 year
Compliance –
Ships With
(1) 14241 Antenna Cable for ET Stations, 59 in.
(2) RF451 900 MHz 1 W Spread-Spectrum Radio
(1) 10873 Serial Data Cable, 9-Pin Female to 9-Pin Male
(1) 15966 Wall Charger with Barrel Plug
(1) 15970 900 MHz 1 dBd Omnidirectional Dipole Antenna with Adhesive Mount
(1) 31008 ET Enclosure Universal Communications Mounting Bracket
(3) 2808 #6-32 x .750 Pan Phillips Stainless-Steel Screw
(1) 17648 USB Cable, Type A Male to Type B Male, 6 ft
(1) — Antenna Mounting Kit

Common Accessories

17548
17548 900MHz 0dBd Omni Antenna w/Type N Female, w/o Mounting Hardware
 
show details
The 17548 is a 0 dBd, unity gain antenna suitable for short, direct line-of-sight transmission. The antenna should reside inside the enclosure.
14203
14203 900MHz 3dBd Omni Antenna w/Type N Female w/o Mounting Hardware
 
show details
This 3 dBd, omnidirectional antenna is suitable for the outdoors. It can be used at the base station or where you need to communicate with multiple stations located in different directions. The antenna is also preferred in applications in which the best radio path is not constant, including close-up applications without clear line-of-sight.
14205
14205 900MHz 6dBd Yagi Antenna w/Type N Female & Mounting Hardware
 
show details
Used outdoors, this high-gain (6 dBd), directional (Yagi) antenna has a narrow beam width that requires precise aiming. Its higher gain makes it useful for communicating over longer distances.

Other Accessories

PS24
PS24-NC-NM
 
PS24 24Ah Power Supply w/10 x 12 Enclosure
 
show details
This power supply is recommended when using a spread spectrum radio with a solar-powered ET station. The PS24 consists of a 24-Ahr sealed rechargeable battery, CH100 regulator, enclosure mounting bracket, and a 10" x 12" environmental enclosure. The enclosure has one conduit for cable entry. The 18520 hanger mounting kit is used to mount the PS24's enclosure onto the ET station's pole (see below).
Charging Regulator Option
-NC -NC No Charging Regulator
-C1 -C1 w/CH150
-C2 -C2 w/CH200
Enclosure Mounts Option
-NM -NM No Enclosure Mounting
-MM -MM Tripod Mast Mounting
-LM -LM CM1xx Leg Mounting
-TM -TM Tower Mounting
-PM -PM Pole Mounting, 4-10in
-EM -EM ET Pole Mounting, 3in
18520
18520 10 x 12 or 12 x 14 Enclosure Mounting Kit w/ Hanger for 3.00 OD Mast
 
show details
The 18520 hanger mounting kit is required to mount the PS24's enclosure to the ET station's pole.

Replacement Parts

20585
20585 ET Enclosure RF450 Mounting Bracket
 
show details
This bracket mounts the RF450 inside of the ET107. It is available to replace a damaged bracket.
20584
20584 ET Antenna Cable BNC to SMA, 13 inch
 
show details
The 20584 cable attaches the RF450 radio to the antenna connector inside of the ET107 enclosure. It may be purchased to replace a lost or damaged cable.
18290
18290 ET Antenna Adjustable Angle Mounting Bracket
 
show details
The 18290 Adjustable Inclination Mount secures the antenna to the ET107's pole. It may be purchased to replace a damaged bracket.
17851
17851 U-bolt w/Saddle Bracket & 2 SB nuts
 
show details
The bracket and u-bolt are included with the 18290 Adjustable Inclination Mount for attachment to the ET107's pole. The 17851 may be purchased to replace a lost or damaged bracket.
15970
15970 900MHz 1dBd Dipole Antenna w/Adhesive Mount & RPSMA Male 79 inch Cable
 
show details
The 15970 is a 1 dBd, omnidirectional antenna. Its adhesive backing adheres to a wall, rear-view mirror, window, or another suitable flat, non-conductive surface. This antenna should reside inside a building or enclosure.
10873
10873 9-Pin Female to 9-Pin Male Serial Data Cable, 6ft
 
show details
The 10873 is a serial cable that is useful for connecting the RS-232 port of the datalogger to the 9-pin RS-232 port of a computer. The cable is six feet long.
15966
15966 Wall Charger 12Vdc 800mA Output, 100-240Vac 50-60Hz w/Barrel Plug, 6ft Cable
 
show details
The 15966 is a charger typically used at the PC where ac power is available.
14241
14241 LMR195 Coax Cable w/BNC Plug to Type N Male, 59 inch
 
show details
The 14241 is used to connect the field site's antenna with the ET station. The cable's length of 59 inches is ideal for attachment to the stations.
31008 ET Enclosure Universal Communications Mounting Bracket
 
show details
The 31008 allows the stacking of multiple communication options.
2808
2808 #6-32 x .750 Screw Pan Phillips SS
 
show details
The 2808 may be ordered to replace a lost or damaged screw.
17648
17648 USB Cable, Type A Male to Type B Male, 6ft
 
show details
The 17648 is a USB cable for attaching our products to a USB port on a PC. It has a type A male connector for connecting to the PC's USB port and a type B connector for connecting to the Campbell Scientific device.