RETIRED ›
This product is no longer available. Some accessories, replacement parts, or services may still be available.

Common Accessories

CABLE5CBL-L
 
CABLE5CBL-L 5-Conductor 22AWG Cable w/Drain
 
This 22 AWG, five-conductor cable has a Santoprene jacket and an aluminum Mylar shield. One CABLE5CBL-L attaches the HUB-SDM5 to the datalogger. You also need a CABLE5CBL-L cable for each of the SDM devices.
CABLE5CBL-L Options - show details
-L ft per cable

Allowed values: 1-1000 ft, increments of 1 ft

Cable Termination Options - show details
-PT -PT w/Tinned Wires
With the -PT option, the cable terminates in pigtails that connect directly to the datalogger.
-PW -PW w/Pre-Wire Connector
Choose this option if you are using this cable with a pre-wired enclosure.
8125
 
If not ordering the datalogger on the same order, you might need this small, flat-bladed screwdriver. The 8125 is extremely useful for opening the guillotine terminals on the HUB-SDM5. The blade is 2.5 mm across and the untapered shaft length is 50 mm. The handle has an approximate length of 9 cm, and features a rotating end-cap that makes the screwdriver easy to rotate.

Replacement Parts

15863
 
The 15863 bracket mounts the HUB-SDM5 to a mast or pipe. It is included with the HUB-SDM5 and may be purchased to replace a bracket that has been lost or damaged.
17492
 
The 17492 provides a 5/16" U-bolt and two nuts. This product is used to mount solar panels, mounts, enclosures, or sensors to a mast, tower, or pole.
4366
 
The 4366 may be purchased to replace a lost or damaged washer.