RETIRED ›
This product is no longer available and has been replaced by: 034B-L.
Product Details
Restockable Yes
Warranty
Compliance

Replacement Parts

 
The 13765 wind vane tail can be replaced by the user.
 
This 10K potentiometer is difficult to replace, and therefore factory replacement is recommended. The 2905 requires recalibration. When Campbell Scientific replaces the 2905, bearings will also be replaced.
 
034BCBL-L 034B-L or 034A-L Replacement Cable
 
This cable can be easily replaced by the user. The 034BCBL-L consists of a 24 AWG cable with a Santoprene® jacket. The cable has a small connector that attaches to the base of the 034A Wind Set.
034BCBL-L Options - show details
-L ft per sensor cable

Allowed values: 1-1000 ft, increments of 1 ft

Custom lead lengths are available for up to 1000 feet. Campbell Scientific recommends:
  • 14 ft—sensor mounted atop a CM106B, CM10, CM110, or UT10 via a CM202
  • 19 ft—sensor mounted atop a CM115 via a CM202
  • 24 ft—sensor mounted atop a UT20 via a CM202
  • 37 ft—sensor mounted atop a UT30 via a CM202
Cable Termination Options - show details
-PT -PT w/Tinned Wires
-PW -PW w/Pre-Wire Connector
With the -PW option, the cable terminates in a connector that attaches to a prewired enclosure.
-CWS -CWS w/CWS900 Connector
With the -CWS option, the cable terminates in a connector that attaches to a CWS900-series interface. Connection to a CWS900-series interface allows this sensor to be used in a wireless sensor network.
-RQ -RQ w/RAWS Connector
16895
 
This calibration screw keeps the vane stationary during the calibration process. The 16895 comes with the 034A and is available as a replacement part.