RETIRED ›
This product is no longer available and has been replaced by: WINDSONIC4-LC. Some accessories, replacement parts, or services may still be available.
Product Details
Typically Ships Within 21 - 28 Days
Restockable Yes
Warranty
Compliance

The "Typically Ships Within" value is an estimate of the number of calendar days within which this product is ready to ship from Campbell Scientific. Orders with more than 10 built-to-order products will likely increase the time needed to prepare the order for shipping.

To estimate how long it will take to receive an order that contains multiple products, combine the longest Ships Within value with the transit time of the shipping method you select.

Some specialized products have long Ships Within values. Because of this, you might consider submitting a separate order for these products so your other products won't be delayed.

Replacement Parts

1163
 
The 1163 consists of a 5/16-18 x 1.75 U-bolt and two nuts. The 1163 is used to mount an enclosure to a tripod, tower, or a 1.0" to 1.25" IPS Schedule 40 pipe.
17386
 
This component of the 17387 is available for customers who need a replacement tube, but do not need the other components of the 17387 Mounting Kit.
17446
 
The 17446 provides a U-bolt and two nuts as a replacement for the original U-bolt and nuts.
4365
 
The 4365 can be purchased to replace a lost or damaged washer.
4366
 
The 4366 may be purchased to replace a lost or damaged washer.
 
WINDSONIC4CBL-L Windsonic Replacement SDI-12 Signal/Power Cable
 
The WINDSONIC4CBL-L connects the WindSonic to the datalogger. It consists of a 22 AWG cable with a pinned military-style connector, and a UV-resistant Santoprene jacket. Maximum cable length is 200 feet.
WINDSONIC4CBL Options - show details
-L ft per sensor cable

Allowed values: 1-300 ft, increments of 1 ft

Maximum Cable Length:
  • 300 ft (SDI-12 output with one sensor connected to a single port)
  • 200 ft (SDI-12 output with two to ten sensors connected to a single port)
Contact Campbell Scientific if longer cable lengths are required.

Campbell Scientific recommends the following cable lengths assuming the sensor is mounted atop the tripod/tower via CM202 crossarm:
  • 13 ft (WINDSONIC4CBL-L13) for a CM106B tripod, CM110 tripod, or UT10 tower
  • 19 ft (WINDSONIC4CBL-L19) for our CM115 tripod
  • 24 ft (WINDSONIC4CBL-L24) for our CM120 tripod or UT20 tower
  • 34 ft (WINDSONIC4CBL-L34) for our UT30 tower
Cable Termination Options - show details
-PT -PT w/Tinned Wires
-PW -PW w/Pre-Wire Connector
With the -PW option, the cable terminates in a connector that attaches to a prewired enclosure.
-C -C w/ET/CS110 Connector
-RQ -RQ w/RAWS Connector