This product is no longer available and has been replaced by: 05108-45-L. Some accessories, replacement parts, or services may still be available.
05103-45-L RM Young Wind Monitor, Alpine Version
05103-45-L Options - show details
-L ft cable per sensor

Allowed values: 0-1000 ft, increments of 1 ft

Custom lead lengths are available for up to 1000 feet. Campbell Scientific recommends:
  • 14 ft—sensor mounted atop a CM106B, CM110, or UT10 via a CM202
  • 19 ft—sensor mounted atop a CM115 via a CM202
  • 24 ft—sensor mounted atop a UT20 via a CM202
  • 37 ft—sensor mounted atop a UT30 via a CM202
Cable Termination Options - show details
-PT -PT w/Tinned Wires
With the -PT option, the cable terminates in pigtails that connect directly to the datalogger.
-PW -PW w/Pre-Wire Connector
With the -PW option, the cable terminates in a connector that attaches to a prewired enclosure.
-CWS -CWS w/CWS900 Connector
With the -CWS option, the cable terminates in a connector that attaches to a CWS900-series interface. Connection to a CWS900-series interface allows this sensor to be used in a wireless sensor network.

Common Accessories

The 17953 NU-RAIL Crossover Fitting can be used instead of the CM220 to attach this sensor to a CM202, CM204, or CM206 crossarm.
The CM220 Right-angle Mounting Bracket attaches this sensor to a CM200-series crossarm.
The CM216 Sensor Mount provides a connection point for this sensor to be attached to the top of a CM106B, CM110, CM115, or CM120 tripod.

Other Accessories

LLAC4 4-Channel Low-Level AC Conversion Module
The LLAC4 can be used to increase the number of sensors measured by one datalogger.
Warranty Lengths - show details
-SW -SW Standard 1yr Warranty
At the time of purchase, the LLAC4 includes a standard warranty of 12 months. See our full warranty policy in the LLAC4 manual for the terms and conditions of this warranty.
-XW -XW 4yr Warr Extension
Our Extended Warranty adds 48 months to the standard 12 month warranty, bringing the total warranty period to 60 months. The extended warranty may be purchased only at the time of original product purchase. It may NOT be "added later." Except for the increased coverage length, the same terms and conditions apply to the extended warranty as apply to the standard warranty.

Replacement Parts

The 13894 bearings are located in the propeller housing. The bearings can be replaced by mechanically-adept users—especially if they are familiar with replacing bearings in other mechanical systems. Otherwise, replacement at the factory is recommended (requires an RMA).
The 13895 bearings allow the wind vane to turn about the axis of the mounting shaft. These bearings are located within the shaft assembly and replacement at the factory is strongly recommended; please request an RMA.
The 3659 is an unthreaded pipe used to mount the sensor to a crossarm. The pipe is easily replaced by the user.