CS650 30cm Water Content Reflectometer Plus
Cable Length Options
-10 -10 w/10ft per probe
-17 -17 w/17ft per probe
-33 -33 w/33ft per Probe
-50 -50 w/50ft per Probe
-U -U w/User Defined Length
-U User Specified Length - show details
-L Pricing is in ft cable per probe

Allowed values: 1-1000 ft, increments of 1 ft

Cable Termination Options - show details
-PT -PT w/Tinned Wires
-PW -PW w/Pre-Wire Connector
Cable terminates in a connector for attachment to a prewired enclosure.
SDI-12 Address Options - show details
-DS -DS SDI-12 Address = 0
SDI-12 Address is set to 0.
-VS -VS SDI-12 Address Varies
SDI-12 Address is set to the last digit of the probe’s serial number (0 to 9).

Add to your Quote List

Product Details
Restockable Yes
Warranty 1 year
Compliance CE Compliance Image RoHS Compliance Image

Common Accessories

The CS650G makes inserting soil-water sensors easier in dense or rocky soils. This tool can be hammered into the soil with force that might damage the sensor if the CS650G were not used. It makes pilot holes into which the rods of the sensors can then be inserted.
The A200 allows the probe to be connected to a computer for changing the SDI-12 address or updating the operating system.

Other Accessories

The 25458 can facilitate wiring when several reflectometers need to be connected to one terminal. This kit contains one 15906 5-inch DIN-Rail Mounting Bracket, two 505 screws, two 6044 grommets, and two 15908 DIN-Rail Stoppers. A complete configuration will also include 25458 connectors, 15907 end plates, and 15920 jumpers (see below).
The 15920 is a DIN-rail mountable terminal connector that can be used between sensors (or other devices) and a datalogger. The 15920 is a three-wire, 4-mm spring-loaded connector.
The 15909 jumper electrically connects terminals on the 15920 connectors (see above).
The 15907 End Plates separate the 15920 connectors.
The 33815 makes it easier for you to connect wires from multiple SDI-12 sensors into one set of terminals on a data logger. The 33815 uses six DIN-rail mountable (pn 27479) 6-wire terminal blocks. The 33815 jumpers two connectors together at a time (pn 32918). This setup allows up to 11 SDI-12 sensors to be connected to one set of terminals on a data logger.