Data Loggers / CR9000
This product is no longer available and has been replaced by: CR9000X.
CR9000 Measurement and Control System
Product Details
Typically Ships Within 21 - 28 Days
Restockable No
Warranty 3 years
Compliance CE Compliance Image

The "Typically Ships Within" value is an estimate of the number of calendar days within which this product is ready to ship from Campbell Scientific. Orders with more than 10 built-to-order products will likely increase the time needed to prepare the order for shipping.

To estimate how long it will take to receive an order that contains multiple products, combine the longest Ships Within value with the transit time of the shipping method you select.

Some specialized products have long Ships Within values. Because of this, you might consider submitting a separate order for these products so your other products won't be delayed.

Other Accessories

Our CR9000 Operator's Manual is provided in paper form (bound in a 3-ring binder).

Replacement Parts

This "blank" (no circuit board or components) occupies one slot in the CR9000 chassis when the slot will be unoccupied by a functional I/O Module, thereby providing a degree of protection for modules in the adjacent slots.
This battery powers the clock and RAM when the primary 12 Vdc power supply is not connected. The battery must be replaced when its voltage falls below 2.4 Vdc.
The 10659 Strain Relief Adapter is attached to the chassis of the CR9000 datalogger, and then cable ties are used to fasten the cables to the adapter. By securing the cables to the data logger's chassis, the likelihood that the sensor cables will be "jerked" out of their screw terminals is reduced.
The CR9011 Power Supply Module provides regulated power to the CR9000 from the internal battery modules. It also regulates battery charging from power supplied by the ac adapter, a dc input, or other external sources.
The CR9041 A/D module provides amplification and signal conditioning for 16-bit, 100 kHz analog-to-digital (A/D) conversions.
The 8989 is a 110-to-240 Vac (input) to 18 Vdc (output) transformer/charger. It connects a wall plug source to the "Charger" receptacle on the CR9011 Card.
The 1113 is used to attach sensor leads to screw terminals.