110PV-L
 
110PV-L Surface-Mount Temp Probe (-40 to +135C)
 
110PV-L Options - show details
-L ft cable per probe

Allowed values: 1-1000 ft, increments of 1 ft

Cable Termination Options
-PT -PT w/Tinned Wires
-PW -PW w/Pre-Wire Connector
-CWS -CWS w/CWS900 Connector
Temperature Calibration
-NC -NC w/No Calibration
-CC -CC w/3-Pt Calibration

Add to your Quote List


Product Details
Typically Ships Within 14 - 21 Days
Restockable Yes
Warranty 1 year
Compliance CE Compliance Image

The "Typically Ships Within" value is an estimate of the number of calendar days within which this product is ready to ship from Campbell Scientific. Orders with more than 10 built-to-order products will likely increase the time needed to prepare the order for shipping.

To estimate how long it will take to receive an order that contains multiple products, combine the longest Ships Within value with the transit time of the shipping method you select.

Some specialized products have long Ships Within values. Because of this, you might consider submitting a separate order for these products so your other products won't be delayed.

Ships With
(2) 2207 4 in. Nylon Cable Tie
(2) 2376 Adhesive-Backed Cable Tie Mount

Common Accessories

 
The 27015 is a 5-yd roll of Kapton Tape. This tape is recommended for fastening the 110PV to the measurement surface when the temperature may exceed 70°C.

Other Accessories

 
The 27015 is a 5 yd roll of Kapton Tape. This tape is recommended for fastening our surface mount temperature sensors to their measurement surface when the temperature may exceed 70°C.

Replacement Parts

2207
 
Two of these 4 in. cable ties are included with the 110PV-L. The cable ties are constructed from a flexible, nylon material. A connection is made by pulling the tapered end through the locking end, thus forming a loop. The free end is pulled tight to secure the cables, then trimmed back to the locking end. Once attached, the cable tie must be cut to be removed.
2376
 
Two of the 2376 cable tie mounts are included with the 110PV-L. They are small, 3 cm square tabs with adhesive backing. The 2376 mounts attach to the inside of an enclosure to provide an anchor for attaching the cable ties. The cable ties, in turn, are used to secure cables and wires, thus providing strain relief and cable routing inside the enclosure.