RETIRED ›
This product is no longer available and has been replaced by: 034B-L.
034B-LQ
 
034B-LQ Met One Wind Set for RAWS Station
 
Cable Length - show details
-LQ ft cable per sensor

Allowed values: 1-1000 ft, increments of 1 ft

Custom lead lengths are available for up to 1000 feet. Campbell Scientific recommends:
  • 11 ft—sensor mounted atop a CM6 via a CM202
  • 14 ft—sensor mounted atop a CM106, CM10, CM110, or UT10 via a CM202
  • 19 ft—sensor mounted atop a CM115 via a CM202
  • 24 ft—sensor mounted atop a UT20 via a CM202
  • 37 ft—sensor mounted atop a UT30 via a CM202
Product Details
Restockable Yes
Warranty 1 year
Compliance CE Compliance Image

Common Accessories

17953
 
The 17953 NU-RAIL® Crossover Fitting is used to mount this sensor to a CM200-series crossarm. It provides equivalent functionality as the CM220 Right Angle Mounting Bracket.
CM220
 
The CM220 Right-angle Mounting Bracket attaches this sensor to a CM200-series crossarm.
CM216
 
The CM216 Sensor Mount provides a connection point for this sensor to be attached to the top of a CM106B, CM110, CM115, or CM120 tripod.

Replacement Parts

13764
 
The 13764 034B Replacement Reed Switch is difficult to replace without shattering the reed switch in the installation process. Factory repair is recommended.
 
The 13765 wind vane tail can be replaced by the user.
15954
 
The 15954 potentiometer and mount assembly is difficult to replace. Factory replacement is recommended. The mount assembly is aligned with the potentiometer allowing a reference point on the potentiometer to be maintained during installation.
16895
 
The 16895 Calibration Screw holds the vane stationary during the calibration process.
3648
 
The 3648 bearing is difficult to replace without shattering the adjacent reed switch. Factory replacement is recommended. Two bearings are required.