Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.
Question/Topic Posted By Replies
LoggerNet Disapearing Options rluthwaite 4
How to set range high and low to correspond to certain values? For barometric pressure sensor SofiaAR 1
Thies 3D Sonic with CR6: every other record is NAN, polling not working fluckste 5
Three dimensional array - using Alias Renewable Joe 1
is wind-speed affect to humidity? to-ya farm 1
when 1 minute-data is created to-ya farm 2
multiple tipping bucket rain gauges with CR1000 ollauri 2
EC5 Sensor Program for CR1000 Bayer1 1
security of connection ( Ethenet vs RS232) to-ya farm 4
Decagon CDT-10 electrical conductivty temperature depth sensors todd_c 1
HTTPGet with multiple header parameters kelley.drechsler 1
Write with ModbusMaster cristian24 1
Switch-closure rain gauges, C terminals on CR300 and the 100 k Ohm resistor rainyday 2
sw12 raid event nmaureira 1
PakBusTcpServer table reset TaCaPica 0
How to interface picarro G2311f analyzer with CR3000 datalogger??? lambros09 1
CR6 and CELL205 Octavio GM 0
SerialInRecord for different instruments in one COM koxme 0
FTP destination requirements - will a cloud server such as Dropbox work as an FTP destination? BenFerguson 23
"NAN" Split and Invalid Float Point Steve 1
wind-direction statistics to-ya farm 0
What "fieldname" I should use to retrive the value of "Maximum" in a Datatable? Specto Technology 1
Programming a CR6 to measure a Plantower PMS5003 PM sensor halo66 3
EmailRelay works the first time but not again bond 2
CO2 probe to CR1000 AdamPFR 4
software program review ( please help me ^^;) to-ya farm 3
FTPClient File Time Range BrianP 1
Kipp & Zonen SUV5-V into a CR3000 md1088 1
CR1000 + AW200 + AM16/32B - multiple NTC 2 wire sensors Bujor.octav 0
Unix timestamp tuandaoht 2