All FAQs (1993 total: showing 961-980)
- Can the 03101-L be installed in a position that is tilted to the horizontal?
- Is a device, such as the COM320, necessary for initiating a call when the measured parameters fall out of a specified range?
- Is a louder male voice available for the COM320?
- Can dual communication modes be run on a single CR1000 using a COM320 and an NL120?
- Can a CWS900-series interface make thermocouple measurements?
- How many CWS900-series interfaces can be put inside an enclosure, such as the ENC10/12, without causing interference issues?
- Does the use of a CWS900-series interface require direct line-of-sight?
- Does PC200W allow adding two different sensors to a multiplexer? If so, how?
- How can control ports be configured so that they can be toggled using the port dialog in PC200W?
- Is there a software upgrade for the PC200W program?
- Does PC200W come with device configuration software, or is LoggerNet needed?
- What is the difference between PC208W and PC200W?
- Can LoggerNet and PC200W run at the same time on the same computer?
- What do “serial port open failed” and “permission denied” error messages mean?
- Does the “delete datalogger” function on the PC200W delete stored data on a data logger, a program, or both?
- How can it be determined in PC200W which units of measurement are being used for a particular parameter?
- Can PC200W be used to clear data from a data logger that does not have a keyboard?
- Using PC200W, how can old files be deleted from the data logger CPU?
- Using PC200W, can real-time plots be generated as the data are acquired?
- On the interface of the PC200W software, it seems as if the Monitor Data tab displays the real-time data. Which table is used from the data logger for this?
Previous
Next