All FAQs (1851 total: showing 821-840)
- What are the mounting options for the CSAT3?
- Is the offset relatively constant for a single CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH?
- How often does a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH anemometer need to be recalibrated?
- Is there a way to determine the time at which the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH started reporting data with sub-second precision?
- How sensitive are the CSAT3A, CSAT3AH, CSAT3B, and CSAT3BH velocity measurements to sea spray in periods of high wind speed?
- Does the head of the CSAT3 need to be matched with its electronic box?
- Can the CSAT3B or CSAT3BH measurement frequency be changed? If so, what frequencies are supported by these sensors?
- Can the connectors for a PWENC enclosure be purchased separately?
- How easy is it to replace a defective component, such as a modem, from inside a prewired enclosure?
- What is needed to connect a modem to a data logger?
- Does the CM375 come with anchors?
- What if I don’t have a Campbell data logger for use with the CS725?
- Can the CS725 output in SDI-12 format?
- Can the CS725 sensor be installed once snow is on the ground?
- When should the CS725 be installed?
- Does the CS725 sensor emit radiation?
- How does the CS725 sensor work?
- If solar panels are not feasible, what type of power supply would work well with a weather station and not require replacement for approximately a year?
- Can power connectors, such as the pin (male) terminal plug that connects the battery leads to the output panel of the BPALK, be ordered?
- If LoggerNet is running on a server behind a firewall, which firewall port needs to be opened to connect to data loggers that each have a GPRS modem and a fixed IP address?
Previous
Next