All FAQs (1754 total: showing 1121-1140)
- Is an individual FCC license required to use a spread-spectrum radio?
- Is there a recommended RF filter for removing local interference while using a spread-spectrum radio?
- Can an RF450 be used to connect a PC to one CR1000 through another CR1000?
- Can the RF450 be used with any RS-232 transmission, or can it only be used with a Campbell Scientific data logger?
- Can a spread-spectrum radio be used as a repeater in an RF telemetry network?
- How can the driver for an RF430-series radio be downloaded?
- Can a spread-spectrum radio be used to connect two computers without a data logger?
- Can the power level of the RF416 be increased or decreased?
- Can an RF401 and an RF450 talk to each other?
- Are CS I/O communications possible with the RF401A, RF401, RF411, RF411A, RF416, or RF450?
- How does a spread-spectrum radio work?
- What is the typical range for the RF416?
- How do the PC200W, PC400, VisualWeather, and LoggerNet software options compare?
- When trying to set up a data logger, why would PC400 not show any COM ports for selection?
- In PC400, in the Monitor Data tab, how can the label (InputLocation) be renamed?
- Can PC400 be used to generate real-time graphs on the screen for measurements from the data logger?
- How is the baud rate set using PC400?
- How are PC400, LoggerNet, and LoggerNet Admin similar and different?
- Can PC400 operate on a 64-bit system?
- Can PC400 be used with a Macintosh computer?
Previous
Next