Select Your Communication Option

Now that you've successfully communicated over USB with your CR300-Series datalogger, select which type of communication you need to set up next:

USB  I only need USB. What's next?

Ethernet  CR310 Ethernet or Ethernet over USB

Radio  CR300 or CR310 RF

Wi-Fi  CR300 or CR310 Wi-Fi

Looking for product information? Go here: CR300 Measurement and Control Datalogger


CR300 Support Resources

  1. CRBasic in the Real World Part 2: Triggering Real-Time Measurements During a Site Visit (10:41)
  2. Fundamentals of CRBasic Programming Part 8: Deploy, Monitor, and Swap MicroSD Cards in the Field (7:41)
  3. Fundamentals of CRBasic Programming Part 6: Loops (9:02)
  4. CR300 and CR310 Getting Started Tutorial
  5. Fundamentals of CRBasic Programming Part 7:Determine If External Memory is Required/Intro to MicroSD (9:19)
  6. CRBasic in the Real World Part 1: Adding a Water Level Measurement (8:28)
  7. Pipeline and Sequential Modes (10:04)
  8. Fundamentals of CRBasic Programming Part 9: Retrieving Data from a MicroSD Card (5:51)
  9. CR300 Datalogger QuickStart (Part 1) (1:47)
  10. Using a Multiplexer (8:27)
  11. CR300 Datalogger QuickStart (Part 2) (5:19)
  12. Double-Precision Calculations (5:50)
  13. IP Networking and Data Loggers Part 2 (9:51)
  14. IP Networking and Data Loggers Part 1 (8:34)
  15. CR300 Datalogger QuickStart (Part 3) (5:36)
  16. Troubleshooting Resistance-Based Sensors (18:23)
  17. Fundamentals of CRBasic Programming Part 5: Conditional Tables (10:51)
  18. Fundamentals of CRBasic Programming Part 4: Programming for Control with Operators and Logical Expressions. (9:05)
  19. CR300 Datalogger QuickStart (Part 4) (3:31)
  20. Toolbox for Installation and Maintenance (2:21)
  21. LoggerNet Software | Changing Variables (2:33)
  22. Troubleshooting Voltage Output Sensors (7:42)
  23. CR300 Series Wi-Fi QuickStart
  24. CR300-Series USB Communications
  25. RF Communication QuickStart
  26. Datalogger Programming
  27. Power Budgeting (4:07)
  28. Built-in Web Interface (2:59)
  29. Ethernet over USB (2:11)
  30. Connect Window Tutorial
  31. Collect Data Tutorial
  32. Certificates of Calibration (1:05)
  33. SDI-12 Sensors | Transparent Mode (7:13)
  34. View Data Tutorial
  35. SDI-12 Sensors | Watch or Sniffer Mode (3:25)
  36. Sending an OS to a Local Datalogger (Part 1) (5:28)
  37. Sending an OS to a Remote Datalogger (Part 2) (5:10)
  38. LoggerNet Software | Network Planner (4:04)
  39. LoggerLink Software | An Introduction (12:11)
  40. Fundamentals of CRBasic Programming Part 1: Variables (13:30)
  41. Fundamentals of CRBasic Programming Part 2: Tables (8:53)
  42. Fundamentals of CRBasic Programming Part 3: Writing a Complete Program (14:51)