the 17206 is an SC-IRDA infrared interface factory installed in the enclosure bulkhead. When you purchase an enclosure and the 17206, Campbell Scientific will install the SC-IRDA in the enclosure bulkhead before the enclosure leaves the factory.The SC-IRDA is secured and sealed in the enclosure with a compression fitting. The SC-IRDA is an infrared interface that facilitates communication between the data logger and an infrared-equipped PDA. This device allows you to interrogate the data logger on site without opening the enclosure.Read More
The 17206 must be ordered at the same time as a standard or prewired enclosure. When the 17206 is ordered, Campbell Scientific will install an SC-IRDA Infrared Interface in the enclosure's case. The SC-IRDA provides an infrared interface that facilitates communication between the data logger and an infrared-equipped PDA. This device allows you to interrogate the data logger on-site without opening the enclosure. PConnect software or PConnectCE software is required. The SC-IRDA is secured and sealed in the enclosure with a compression fitting.
|Power||Supplied by data logger 5 V (on CS I/O port)|
|Typical Current Drain||
Rates up to 19200 selectable via software.
|Communication Range||Up to 20 cm (8 in.) with typical lighting|
|Communication Standard||Conforms to the IRDA low power SIR specifications as supported by most Palm PCs and laptops.|
|PDA Handheld Requirements||Must have an IRDA sensor and an IR chipset compatible with the SC-IRDA. (See PConnect or PConnectCE product brochure for other PDA requirements.)|
|CE Compliance||Complies with EMC standard EN61326:1996.|
Note: The following shows notable compatibility information. It is not a comprehensive list of all compatible or incompatible products.