SDM8X50 8-Channel Solid State 50 Ohm Coax Multiplexer
Enclosure Option
-N -N w/o Enclosure
-E -E w/10x12 Enclosure

Add to your Quote List

Product Details
Restockable Yes
Warranty 1 year
Compliance CE Compliance Image RoHS Compliance Image
Ships With
(8) 505 Screw #6-32 x .375 Pan Phillips
(8) 6044 Grommet for #6 or 8 Screw
(20) 2207 4 in. Nylon Cable Tie
(1) Support Bracket with 12 Cable Tie Mounts

Common Accessories

COAXTDR-L TDR Multiplexer Cable RG8 w/2 BNC Male Connectors
This low-loss coaxial cable connects different levels of SDM8X50s or connects the Level 1 SDM8X50 to the TDR100.
Cable Length - show details
-L Pricing is in ft per TDR cable

Allowed values: 1-500 ft, increments of 1 ft

Cable length is user-specified.
CABLE5CBL-L 5-Conductor 22AWG Cable w/Drain
This cable connects the datalogger to the SDM8X50. The CABLE5CBL-L is a 22 AWG, five-conductor cable with a Santoprene jacket and an aluminum Mylar shield.
CABLE5CBL-L Options - show details
-L Pricing is in ft per cable

Allowed values: 1-1000 ft, increments of 1 ft

Cable Termination Options - show details
-PT -PT w/Tinned Wires
With the -PT option, the cable terminates in pigtails that connect directly to the data logger.
-PW -PW w/Pre-Wire Connector
Choose this option if you are using this cable with a pre-wired enclosure.

Other Accessories

This 18 in. long, 50 ohm, RG58 coaxial cable is fitted with BNC male connectors on both ends. It connects the TDR100 to the Level 1 SDM8X50 in a TDR system.
The ENCTDR100 is a white fiberglass-reinforced polyester enclosure that protects the TDR equipment from weather, condensing humidity, and dust. With internal dimensions of 16" x 18" x 8", it can house the datalogger, power supply, TDR200, and SDM8X50-N.

Replacement Parts

The 8039 is a type L mechanical connector used for connecting a grounding wire to the SDM8X50. It is fastened in place with the 8673 #10-32 Nylock Nut.
The 8673 attaches the 8039 Ground Lug Connector to the SDM8X50.
These screws, along with the 6044 grommets, are commonly used together to secure our equipment to the backplates of our enclosures.
These grommets are commonly used with the 505 screws to secure our equipment to the backplates of our enclosures.
The cable ties are constructed from a flexible, nylon material. A connection is made by pulling the tapered end through the locking end, thus forming a loop. The free end is pulled tight to secure the cables, then trimmed back to the locking end. Once attached, the cable tie must be cut to be removed.
The 28764 may be ordered to replace a damaged enclosure.
The 560 screw is used to attach a backplate to the inside of an enclosure.