RETIRED ›
This product is no longer available and has been replaced by: 108. Some accessories, replacement parts, or services may still be available.
108-LC
 
108-LC Temp Probe (-5 to +95C) for MetData1
 
Cable Length - show details
-LC ft cable per probe

Allowed values: 1-2500 ft, increments of 1 ft

Custom lead lengths are available for up to 1000 feet. Campbell Scientific recommends:
  • 9 ft length (108-LC9) attached directly to mast/leg at a 2 m height
  • 11 ft length (108-LC11) attached to a CM202 at 2 m height
  • 14 ft length (108-LC14) attached atop a CM106B, CM110, or UT10 via a CM202
  • 19 ft length (108-LC19) attached atop a CM115 via a CM202
  • 24 ft length (108-LC24) attached atop a UT20 via a CM202
  • 37 ft length (108-LC37) attached atop a UT30 via a CM202
Add two feet to the cable length if you are mounting the enclosure on the leg base of a CM106B, CM110, CM115, or CM120 tripod.

Common Accessories

41303-5A
 
A naturally aspirated radiation shield is required for outdoor use. The 41303-5A Radiation Shield mounts to our tripods and towers.
RAD06
 
The RAD06 uses a double-louvered design that offers improved sensor protection from driving rain, snow, and insect intrusion. It also has lower self-heating in bright sunlight combined with higher temperatures (> 24°C (~75°F)) and low wind speeds (< 2m/s (~4.5 mph)), providing a better measurement.
 
TEMPCAL Calibration Setup Fee
 
The TEMPCAL is available at time of purchase. It provides a single-point calibration and a calibration certificate. The single-point calibration determines the offset at 25°C with an uncertainty of ±0.05°C. Calibration after purchase requires an RMA.
Qty 1-Point Calibration - show details
-CC 1-Pt Calib on Probes

Allowed values: 1-1000 ea, increments of 1 ea

The setup fee is assessed for all probes in the "run"; the 1-point calibration fee is assessed per probe.
 
TEMPCAL2 Calibration Setup Fee
 
The TEMPCAL2 is available at time of purchase. It provides a two-point calibration and a calibration certificate. Calibration after purchase requires an RMA.
Qty 2-Point Calibration - show details
-CC 2-Pt Calib on Probes

Allowed values: 1-1000 ea, increments of 1 ea