This product is no longer available.
| Services Available | |
|---|---|
| Repair | No |
| Calibration | No |
| Free Support | No |
Overview
The MCR1 is only compatible with our mixed-array data loggers and the DSP4 Heads Up Display. (See the Compatibility information.) In a single package, it includes both the CSM1 and a SC532(A). The MCR1 connects to an IBM-compatible computer via a 7026 cable (supplied). AC power and SMS software are required.
Please note that availability varies by country; please contact a Campbell Scientific office or representative to discuss your data storage requirements.
Read MoreImages
Detailed Description
The MCR1 is only compatible with our mixed-array data loggers and the DSP4 Heads Up Display. (See the Compatibility information.) In a single package, it includes both the CSM1 and a SC532(A). The MCR1 connects to an IBM-compatible computer via a 7026 cable (supplied). AC power and SMS software are required.
Please note that availability varies by country; please contact a Campbell Scientific office or representative to discuss your data storage requirements.
Specifications
| Memory Configuration | Fill-and-stop; data segregated into files by filemarks |
| Baud Rate | Data transfer is typically 9600 or 19,200 baud. Contact Campbell Scientific for information on using the module with Burst Mode. |
| Supply Voltage | 110 Vac to 7.5 Vdc adapter (factory installed) or 6 to 17 Vdc (with modification by user) |
| Interface Type | 25-pin, D-type sub-miniature socket, RS-232C DCE interface |
| RS-232 Output Levels | 5 V (minimum with 3000 Ω load) |
Current Drain @ 25°C |
|
| Quiescent | RTS low = 16 mA (maximum) |
| Active | memory test (worst case) = 30 mA (typical) |
RS-232 Input Levels |
|
| Low Threshold | 0.8 V (maximum) |
| High Threshold | 2.0 V (minimum) |
| Maximum Input Limit | 30 V |
| Minimum Input Resistance | 3500 Ω |
Compatibility
Note: The following shows notable compatibility information. It is not a comprehensive list of all compatible or incompatible products.
Data Loggers
| Product | Compatible | Note |
|---|---|---|
| 21X (retired) | ||
| CR10 (retired) | ||
| CR1000 (retired) | ||
| CR10X (retired) | ||
| CR200X (retired) | ||
| CR206X (retired) | ||
| CR211X (retired) | ||
| CR216X (retired) | ||
| CR23X (retired) | ||
| CR295X (retired) | ||
| CR3000 (retired) | ||
| CR500 (retired) | ||
| CR5000 (retired) | ||
| CR510 (retired) | ||
| CR800 (retired) | ||
| CR850 (retired) | ||
| CR9000 (retired) | ||
| CR9000X (retired) |
Communication Devices
| Product | Compatible | Note |
|---|---|---|
| DSP4 (retired) |
Additional Compatibility Information
Data Logger Considerations
The MCR1 is only compatible with mixed-array data loggers (see below). Data loggers that store data in a table-based format are not compatible. Older data loggers may require a PROM upgrade.
Memory Card
The MCR1 uses one JEIDA 4, PCMCIA card; proper MCR1 operation is guaranteed only with cards tested by Campbell Scientific.
Documents
Manuals
Privacy Policy Update
We've updated our privacy policy. Learn More
Cookie Consent
Update your cookie preferences. Update Cookie Preferences