FAQs Frequently Asked Questions about Our Products and Solutions

Can the SR50A-L be recalibrated?

The sensitivity can be adjusted slightly at the factory, but it cannot be recalibrated. Typically, the transducing diaphragm needs to be replaced periodically to maintain calibration. This can be done by the user or at the factory.

FAQs Home

Search

Similar FAQs

• What are the different cable termination options available for Campbell Scientific sensors?
• How far can an SDMX50-series or SDM8X50 multiplexer be separated from a TDR100 or TDR200?
• If an SR50A-L is used to measure snow depth at a site that has wind, rain, and extreme changes in temperature, which results in condensation, what can be done to ensure the sensor operates properly?
• Where are the available cable termination options listed for a particular sensor?
• What are the different cable length choices available for Campbell Scientific sensors?
• What are possible causes for the message “Classic::CmdClockSet”?
• What is the maximum cable length available for the SR50A-L?