FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1993 total: showing 1641-1660)

What is the maximum input voltage that a VDIV2:1 or VDIV10:1 can handle?
What principle does the control line of the CE4 and CE8 work with? Is it a digital signal or an analog voltage?
Can a CE4 or CE8 be used as a current source, measuring the voltage drop across a resistor to calculate resistance?
Can the CE4 and CE8 be used to make measurements of a non-bridged PRT?
Is there a specific type of wire that should be used to connect the 12 V and ground terminals on the CE4 or CE8 and the data logger?
What is the expected current drain for the 12 Vdc supply for a CE4 or CE8 module when CTRL is high?
What is the output voltage and intensity of the CE4 and CE8 modules?
What is the purpose of the CE4 and CE8?
If a data logger is not registering any tips, what can be done?
What are the indicators that a tipping bucket rain gage has a faulty reed switch?
What can cause a data logger to not receive correct tipping data?
What are the steps to perform a field calibration check on a TB4-L, a TB4MM-L, or a CS700-L?
What can cause a tipping bucket rain gage to be out of calibration?
What are the indicators that a tipping bucket rain gage is out of calibration?
What are the most common errors with a tipping bucket rain gage?
Can the A200 be used to monitor the input and output of pressure and temperature transducers through a computer?
Why might an SDMX50-series multiplexer make clicking sounds?
Are SDMX50-series and SDM8X50 multiplexers only usable with the TDR100 or TDR200 system?
Does an SDMX50-series multiplexer require a separate power supply?
How far can an SDMX50-series or SDM8X50 multiplexer be separated from a TDR100 or TDR200?

Previous Next