FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1851 total: showing 1601-1620)

Can a network camera be connected directly to a CR1000 or CR3000?
What is the maximum input voltage that a VDIV2:1 or VDIV10:1 can handle?
What principle does the control line of the CE4 and CE8 work with? Is it a digital signal or an analog voltage?
Can a CE4 or CE8 be used as a current source, measuring the voltage drop across a resistor to calculate resistance?
Can the CE4 and CE8 be used to make measurements of a non-bridged PRT?
If a data logger is not registering any tips from a rain gage, what can be done?
What are the indicators that a tipping bucket rain gage has a faulty reed switch?
What can cause a data logger to not receive correct tipping data from a rain gage?
What are the steps to perform a field calibration check on a TB4-L, a TB4MM-L, or a CS700-L?
What can cause a tipping bucket rain gage to be out of calibration?
What are the indicators that a tipping bucket rain gage is out of calibration?
What are the most common errors with a tipping bucket rain gage?
Can the A200 be used to monitor the input and output of pressure and temperature transducers through a computer?
Why might an SDMX50-series multiplexer make clicking sounds?
Are SDMX50-series and SDM8X50 multiplexers only usable with the TDR100 or TDR200 system?
Does an SDMX50-series multiplexer require a separate power supply?
How far can an SDMX50-series or SDM8X50 multiplexer be separated from a TDR100 or TDR200?
Where is PC-TDR available for download?
How can two independent solar power systems be connected to an AP200 if each system has a lead-acid battery, solar panel, and charger?
Where should a sensor that requires 12 Vdc power be connected to on the AP200?

Previous Next