All FAQs (1754 total: showing 1461-1480)
- Can two of the same sensor be wired to the same COM port on a data logger, with each sensor sending separate data files to the data logger?
- Using RTMC Pro, is there a way to set up email alerts for a complete data logger failure?
- Is there a GPS interface that can be used to keep a data logger synchronized with GPS time?
- If an RF modem is used to communicate with a data logger and a PC running LoggerNet, but the modem baud rate is one third of the data logger baud rate, is that a problem?
- Why might a data logger refuse having a file uploaded to it?
- Is there a free software package that allows the generation of programs that can sample data on the RS-232 or COM port of the data logger?
- If a data logger OS has not been upgraded in a long time, can the most current OS be downloaded, or do the upgrades need to be done incrementally?
- Can two data loggers be connected over the RS-232 port, or do they need to use the COM ports to connect?
- How often is the lithium battery voltage measured by the CR1000?
- If a data logger has not been used in a while and the internal battery is low, will the battery recharge if the data logger is connected to a power supply? Or does the battery need to be replaced?
- Is data lost when the data logger battery runs out of power in the field or is disconnected, and a “table definitions out of date” error message appears upon powering up?
- Which CRBasic instruction is used to activate the 7321 relay?
- Can a data logger accept PakBus connections from multiple terminals simultaneously?
- Can an RS-232 device be directly connected to the CS I/O port of a data logger?
- How can the data logger be used to produce analog voltages?
- What is the difference between the various bridge measurements?
- What might cause data logger clock issues?
- What might cause a data logger to not store data at a particular time, such as midnight?
- What might cause error messages such as “transaction failure” and “unreachable destination” when trying to connect a data logger and a PC using a serial or USB to RS-232 cable?
- How can variables be saved so that they are available for use after the data logger power has been removed and the data logger has been powered up again?
Previous
Next