I'm having a problem using the datalogger Terminal Emualtor Serial Talk Through (P) mode. (CR1000 and CR3000). I get the "CR1000>" prompt with no problem, and have no issues with Comms Watch (W command). However, when try option P on the same COM port, I get a response that the port is opening, but when I try to send a command to the device, nothing happens. Hitting ESC a few times brings me back out.
If I connect to the datalogger with a RS-232 cable, I can do both P and W, but not using the Terminal Emulator on PC200W, or from LoggerNet Connect. I'd like to be able to do this remotely. It would save a 75-mile drive to the devices.
Thanks for any help.
Is this solved? I have the same issue - W mode works for me, but P mode was stuck after I chose the port.
is the serial port open and disponible?