Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CR6 with Vibrating Wire Gage and Quarter Bridge Strain Gage of Another company


dewan_001 Jul 19, 2016 03:27 PM

Hello there,

I will be using Geokon Model 4200 Vibrating Wire Gage. Also, I have a CR6 data logger from Campbell Scientific. But I am having hard times how to connect the Geokon VWG Model 4200 with CR6  ( both wiring and software connection).

Same thing happened when I tried to connect A 3wire quarter-bridge strain gages with CR6. I am not finding any video or step by step connect manual for hardware wiring and software support. 

Any quick and easy suggestion to the above-mentioned problems would be highly beneficiary?   

Please help me. 


JDavis Jul 19, 2016 04:21 PM

I suggest using the ShortCut program generator. The sensors you mentioned are in ShortCut in the Geotechnical & Structural section.

ShortCut is featured in many of our tutorial videos.

https://www.youtube.com/watch?v=L4rP3Nz-hJM


#RD@2020 Jul 16, 2020 10:58 AM

Hi there,

I'm using CR6 series, AM16 Multiplexer, and 12 Strain gauge vibrating wires, would you mind to share your program?

I'm using a shortcut method for programming but it didn't work for me.

Thanks!

Log in or register to post/reply in the forum.