Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Firmware upgrade causes issues with data and TX321-G GOES transmissions/decode


dfrohbieter Sep 27, 2024 04:00 PM

I have two streamgauge locations that I have recently upgraded the firmware in the CR300 to the latest version (11.01) from much older firmware versions and it caused some kind of program corruption where the data being transmitted over GOES through TX321-G transmitters is all scrambled up and not decoding properly. Has anyone else had this issue?

Log in or register to post/reply in the forum.