Hi
Which voltage is used with PulsPort on a CR6 using U-ports?
Is it 5.0 or 3.3 volts?
Does PulsePort start with high or low level?
Or depens it on which level the port is when the instruction is executed?
Will say: When the port is previousely set to a high state "PortSet(U4,1)". Then it will go from high to low to high, and then a second time to low to high?
When previousely set to low "PortSet(U4,0)". Then it will go from low to high to low, and then again to high to low?
This post is under review.
This post is under review.
The intended function of PulsePort is to convert low-level analog signals. Switching currents exceeding 30 mA will degrade the relevant relay dinosaur game contacts, causing...