Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.

Log in or register to post/reply in the forum.

EmailRelay Limits.

TLT Dec 12, 2023 03:07 AM

Hi All,

I wonder how is the emailrelay daily limit counts, counting by how any time we excute the EmailRelay instruction or the number of email address we send to?

I have 3 sets of Dataloggers sending out data hourly and email a low battery alert. 3 sets of Datalogers send to same 2 email addresses, hits the limit after working for 12 hours. I am using 2 EmailRelay instructions as below: 

EMAIL_HOURLY_result1 = EmailRelay (EMAIL_TO_ADDRESS1,EMAIL_HOURLY_Subject,EMAIL_HOURLY_Message,email_ServerResp_HOURLY1,ATTACHMENT_Record,0,EMAIL_HOURLY_Record,Min,8) 

EMAIL_HOURLY_result2 = EmailRelay (EMAIL_TO_ADDRESS2,EMAIL_HOURLY_Subject,EMAIL_HOURLY_Message,email_ServerResp_HOURLY2,ATTACHMENT_Record,0,EMAIL_HOURLY_Record,Min,8) 

Please advice.



smile Dec 16, 2023 11:34 AM

If I remember correctly it's 100 per day for each recipient


marryjoy6374 Dec 22, 2023 06:58 AM

This post is under review.

TLT Dec 24, 2023 01:52 AM

Hi Smile,

Thanks for your reply.

Yes, you are correct. I counted the emails received is about 100 emails for each recipient, couldn't get a exact number due to the different in time zone.



polinkuer12 Dec 24, 2023 08:05 AM

How to accurately check up to 100 emails per day?

 Quick Draw

bekean24 Jan 23, 2024 02:35 AM

Since you are sending low battery alerts to the same two email addresses from multiple Dataloggers, consolidating recipients can be beneficial. Instead of sending separate emails for each set of Dataloggers, consider sending a single email to both recipients.


TLT Jan 25, 2024 11:15 PM

Hi bekean24,

Do you mean two emails addresses in one EmailRelay command? I tried, but I just cannot get the code right.

Could you please share a sample code with me.


Lisa Dsouza Feb 15, 2024 07:26 AM

This post is under review.

Log in or register to post/reply in the forum.