Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Two 4-20 ma Sensor on one Differential channel in CR1000

heman728 May 5, 2023 05:07 AM

Dear,

I Have CR1000 and only one Differential channel is left available. I want to connect 2 temperature sensors having 2 wire 4-20 ma output. I am using a two100 ohm resistor ( ±0.03%,2PPM) for current to voltage conversion. I am using a separate 24V Power supply. Can I measure 0-100 degree celsius at ±0.5°C accuracy on a single-ended channel?

Ground is common for External 24v supply and Campbell Differential Channel 3 ground.


The Diagram is attached in the following link.


https://drive.google.com/file/d/19QS0KlKS7kFP4wf2GYc9ZKj_1COHLMIY/view?usp=sharing

Link for Diagram

JDavis May 11, 2023 04:03 PM

You need two resistors wire them as separate SE voltage measurements.

Log in or register to post/reply in the forum.