Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Kipp and Zonen CMB6 CMP6


AMK Jul 13, 2021 12:10 PM

Hello Forum,

We have an older K&P CMB6 that has water under the outer glass lens. The manual doesn't specifically mention the best way to dry this surface. Is there a best practice for this or a general technique that works?

Thanks again


AMK Jul 13, 2021 02:55 PM

Solution: Remove sensor body body attachment bolts, remove three allen head bolts, slip upper housing off sensor body, wipe with kimwipes. That's not really written in the manual, so I'm wondering if this should be a standard field practice or not. 


Nico Jul 16, 2021 02:43 AM

I don't have one of those, but wouldn't the seals (prob O-Rings? + some appropriate silicone grease) make sure it stays dry in there?
Any stashes/pockets for dessicant bags in that sensor housing?

As for Silicone Grease I'm using Molykote 111 for things like that.

Log in or register to post/reply in the forum.