Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.

Log in or register to post/reply in the forum.

window 10 pro update and LoggerNet connection

to-ya farm Jun 9, 2021 03:09 AM

hi. ^^


 I installed LoggerNet to 2 computers( 1. desktop, 2. notebook)

 In korea. evening and night may 30, there is many thunders.

 desktop is gone. T.T  ^^:

 for backup, i installed LoggerNet to notebook( dell, window 10 pro) on december 30/12/2020

 that time, my notebook connected to CR1000X via USB. I could use LoggerNet.

 But, 04/06/2021 I could not connect to CR1000X

 for 6 months, there was not much change. mostly window update and kaspersky and brave browser and avast secureline vpn and korean word program.

 sometimes used internet for normal things.

 maybe window 10 pro-update can cause this?


thx ^^

pokeeffe Jun 9, 2021 06:22 PM

Did you verify Loggernet uses the right COM port? It may have changed without you noticing.

to-ya farm Jun 10, 2021 05:17 PM

hi. pokeeffe

 how can i check COM port-change ?

 desktop used RS232(RJ45).

 notebook use USB(micro 5 pin)


pokeeffe Jun 10, 2021 05:38 PM

Open Loggernet Setup Screen and click the ComPort device for your logger. You may need to change the ComPort Connection or reinstall the USB driver.

to-ya farm Jun 11, 2021 10:14 AM

hi. pokeeffe

 In Setup Screen, ComPort Connection was COM3 so I click and see CR1000X(COM5).

 Is it ok to choose CR1000X(COM5) ?

 and I click button of install USB Driver then " no USB driver found" came out.

 how can i find USB Driver?


thx ^^

pokeeffe Jun 11, 2021 05:34 PM

Sounds like you don't need the usb driver, but if you do, DevConfig comes bundled with them.

to-ya farm Jun 12, 2021 02:44 AM

hi. pokeeffe

 thx. it works.


Log in or register to post/reply in the forum.