Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

terminal emulator


elite Feb 15, 2021 03:30 AM

Hello All,

SerialOut (COMU3,"poll" + CHR(13),"",0,0) command works fine in the program and datalogger successfully sends poll command to my device. But if I try to call this command via terminal emulator nothing happends and no return from the sensor. I am doing all these in P mode over terminal emulator. 

I tried pasting "poll" and pressing enter button but there is no return from the device. I tried poll<CR> and enter, again no return.

Short of long, how can I send carriage return via terminal emulator?

All the best,

Göksel

Log in or register to post/reply in the forum.