Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

RS232 - RS485 Cable & Pinout Modbus


Nicolas Jan 7, 2021 03:12 AM

Hello,

I want to connect the COMRS232 port of a cr300 to an RS485 adapter ( https://www.digitus.info/de/produkte/kabel-und-adapter/computerkabel/serielleparallele-kabel-und-adapter/da-70161/ ) in order to establish a communications network with Modbus sensors. What type of cable should I use between the CR300 and the adapter? Rx to Tx (and Tx to RX) or Pin to pin? Which pins of the DB9 connector are actually used?

Thanks in advance,

Nicolas


Nicolas Jan 10, 2021 07:41 AM

After performing some tests, I found the answer. Only the Rx, Tx and ground PINs are required. Rx to Tx and Tx to Rx. Hoping to be useful to others

Log in or register to post/reply in the forum.