Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Send one way data between data loggers using IP


R.AriasFont Mar 9, 2020 02:55 PM

Hi all, 

I will like to send some data between two CR1000X. Both of them are connected using fix IP addresses and are two far apart to make a wire them. I have seen this can be done using commands as DataSend, but I am struggling to understand how to specify the IP address of the other data logger. 

Could someone provide with an example of a basic program? 

Thanks a lot for your help in advance, 

Best, 

Raquel


GaryTRoberts Mar 10, 2020 09:28 AM

I would use the PakBus TCP Client setting in one datalogger to link the two together via TCP/IP. Both datalogger will need to have different PakBus addresses before setting this up. Once the dataloggers are links by this setting, then doing a SendData from one datalogger to another should do the trick (using the Route option for the comport).

Log in or register to post/reply in the forum.