Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.

Log in or register to post/reply in the forum.

CR1000x acting as a modbus slave and acquiring data from modbus sensors

Nick@DTU Jan 4, 2020 07:33 PM


My question is if a CR1000X logger running as a modbus slave can use the modbusmaster() command within its program to aquire data from modbus RTU device? Or is it the case that the logger can only acquire analog measurements when operating as a slave?

I'm aware that a modbus RTU network can only have one master, so I imagine the answer to my question is no, but I'm hoping it's somehow possible.


Tristenp1207 Jun 16, 2021 02:33 PM


Have you found a solutions to this? I'm wanting to do the same thing.

Log in or register to post/reply in the forum.