Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CR6-RF407 Beacon


ariklee Sep 3, 2019 07:13 AM

It is my understanding that the CR6-RF407 uses SDC7 for the internal RF407. In the settings table under "ComPort Settings", there is a setting for beacon interval under both SDC7 and ComRF. Which one do I use for the RF407 beacon interval?  Thanks,


GaryTRoberts Sep 3, 2019 08:09 AM

With the CR6-RF407, the radio is internal (inside the CR6's case/body), so the port used is ComRF. That is the one you need to set the beacon interval on. When using a standalone RF407 connected to the CR6 via CS I/O, the default  commumications port address is SDC7. I think that is where the confusion is coming from.


ariklee Sep 3, 2019 08:17 AM

Thank you. And a CELL-205 connected to the CR6-RF407 via the CS-I/O port defaults to SDC8?


GaryTRoberts Sep 3, 2019 08:23 AM

Yes, that is correct.

Log in or register to post/reply in the forum.