Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.

Log in or register to post/reply in the forum.

LNLinux and RF407 communication

stephen_9 Jul 25, 2019 11:20 AM

I'm attempting to connect a RF407 to our LNLinux server. I can see the usb connection ("lsusb") however cannot connect to it with the Campbell scientific software interface (Only shows COMM1 or ttys0). Any thoughts or direction to the right documentation for this would be greatly appreciated.



JDavis Jul 25, 2019 01:52 PM

There are not Linux drivers for the USB ports on Campbell Scientific products. If you cannot get the connection working direct to the RF407, you should connect an RS232 of the PC to the RS232 port of the RF407. You should be able to find a Linux driver for a USB to RS232 cable such as part 17394. That cable uses a common FTDI chip.

Log in or register to post/reply in the forum.