Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

How can I connect a CR5000 and a CR1000 using 3 MD485 modens?


Georgia Dec 4, 2017 10:21 AM

How can I connect a CR5000 and a CR1000 using 3 MD485 modens?
Is this possible? What would the configuration of the modens be like?

Thank you so much.


JDavis Dec 4, 2017 12:25 PM

The CR5000 does not support Pakbus, so it would only work in MD9 emulation mode. There is a section in the MD485 manual.


jtrauntvein Dec 4, 2017 01:03 PM

I believe that the CR5000 does support both the ModBusMaster() and ModBusSlave() instructions so it may be possible to transfer data using ModBus protocol.

Log in or register to post/reply in the forum.