Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

protocol commands terminal datalogger

kokihualpa Nov 30, 2017 02:46 PM

Hi there

I want to know how I can get communication with a datalogger for example CR1000 with a hyperterminal and using commands for extract information.

I want this alternative mode for I use instead of loggernet.

JDavis Nov 30, 2017 03:51 PM

If you send the datalogger carriage returns, it will give you a command prompt.

You can then send it "H" followed by a carriage return to get a list of available commands.

Log in or register to post/reply in the forum.