FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1993 total: showing 1861-1880)

What might cause a CR23X to lock up and display an "E08 Watchdog Reset" error?
Is it possible to use the BMP5 Direct SDK to connect to a data logger via a modem?
How can a data table on the data logger be deleted using the simplepb.dll library?
Can BMP5 Direct SDK software be used to interface/interact with a CR206X/CR211X datalogger via an RF416/RF411 connected to a PC serial port?
If a facility has ordered the RTDAQ software but wants to start using it right away, can a copy of the software be downloaded from the Campbell Scientific website?
Does CRBasic have to be used to program a data logger? Does a menu-driven program generator exist for the data logger?
The CR1000/CR3000 wiring panel shows four serial I/O ports on C1 to C8. Do these serial I/O ports provide the same functionality as the SDM-SIO4 module did on a CR10X or CR23X datalogger?
Where can example programs be found?
Is there a low-end weather station that will interact or initiate a rain shut command for the Legacy Genesis 3 Central Control software?
What are the key parameters that have to be measured to determine the amount of water needed for irrigation?
What is the 229-L heating element made of? In an acidic environment, such as copper mine tailings, would the sensor be expected to fail because of corrosion within five years?
What is the optimum calibration frequency for a WindSonic?
Is it possible for a WindSonic to operate in extreme conditions like snow, glacial temperatures, and freezing rain?
Where is the interface cable for the WindSonic?
Can vertical wind speed be measured by rotating the WindSonic 90 degrees?
Can the WindSonic produce an output of 4 Hz or higher frequency?
The WindSonic has the average 1 Hz output of 40 Hz block measurements. What does the 40 Hz block measurement mean?
Is it possible to connect a sonic anemometer and an electronic compass to a smart data logger to give wind speed and direction on a non-fixed platform?
If data is downloaded to a PC, the resultant “CR1000_Table1.dat” file is, for example, 150 kB in size. Is 150 kB necessarily its size on the CR1000? Is there any type of data compression being used?
Can the CR1000 or CR3000 communicate over TCP/IP?

Previous Next