All FAQs (1851 total: showing 1801-1820)
- What is the procedure for orienting a WindSonic-L to the cardinal directions, so that the wind direction readings are correct?
- Can the CR5000 store data with a rate of 1000 Hz?
- Is the 03101-L capable of delivering a 0 to 5 Vdc square wave output for the wind speed?
- Do heater resistance values of 37 to 48 ohm indicate a problem with the 229-L, or are those values within the normal range?
- Is there a limit to how much memory the CR5000 can access/use through the PCMCIA interface?
- Is it possible to transfer data from PC400 directly to a database such as Oracle (possibly through ODBC on Windows)?
- What might cause the 014A-L to miss data, provide readings of 0 constant wind speed, and show various readings of gust speed?
- Is the CC640 a real-time camera?
- How many data lines can a SM192 and a SM4M store using a simple program?
- How high above the ground should a net radiometer be placed?
- How many solar panels can be connected to a CH100 regulator? Can one 60 W solar panel and two 20 W solar panels be connected to the same regulator?
- What is the pin connection between USB and DB9 (RS-232) connectors?
- If an existing wind set is replaced with a wind monitor (05103-L, 05103-45-L, 05106-L, 05305-L), will more than the multiplier and offset have to be changed in the data logger program?
- How can the 229-L be calibrated?
- How are readings obtained from the 229-L?
- Is calibration of the 229-L available?
- If several 229-L probes begin returning very low positive and negative values for dT, what might be the cause?
- How should the AM25T be used?
- Can the AM25T be connected to an analog input channel on a device other than a data logger, such as a programmable logic controller (PLC)?
- How can the data logger build a text string and send it out the RS-232 port?
Previous
Next