ENC14/16

28878

Replacement Enclosure Humidity Indicator Card

The 28878 is a replacement humidity indicator card. It provides a visual reference of humidity level inside the enclosure. Colored circles change color from blue to pink to indicate humidity levels of 30%, 40%, and 50% relative humidity. Double sticky tape on the back of the card allows it to be easily secured to an enclosure lid.

18823

Universal Backplate for ENC14/16 Enclosure

This aluminum backplate is pre-punched with a matrix of half-inch-on-center holes. It is available as a replacement part for an existing ENC14/16 enclosure in case a mishap should befall the original backplate. Like our other backplates, the 18823's grid of holes accommodate 6044 grommets and 505 screws.

18957

ENC14/16 Tripod Leg Mounting Kit

This bracket is the same as the "-LM" option. It may be ordered as a replacement part if the bracket gets damaged or if another option was originally chosen.

7363

Enclosure Supply Kit, Standard Size

The enclosure supply kit includes desiccant, a humidity indicator card, cable ties, wire tie tabs, putty for sealing the conduit, and screws and grommets for attaching peripherals to the enclosure backplate.

795

Stainless-Steel Nylock Nut 1/4-20

A couple of these nuts are attached to the enclosure bracket. The nut may be purchased to replace a lost or damaged nut.

5449

Enclosure Ground Lug

The 5449 ground lug is attached to the enclosure. It may be purchased to replace a lost or damaged ground lug.

23

Stainless-Steel Nut #10-32

The pn 23 nut is available as a replacement item.

25744

1-1/2 Panel Bushing Pin (Male)

The 25744 and 25746 are the two parts used to create the standard conduit for Campbell Scientific enclosures. If a portion of the conduit for an ENC or PWENC enclosure becomes lost, the 25744 and 25746 can be ordered as replacements.

25746

1-1/2 PVC Coupling PVC Female Adapter

The 25746 and 25744 are the two parts used to create the standard conduit for Campbell Scientific enclosures. If a portion of the conduit for an ENC or PWENC enclosure becomes lost, the 25746 and 25744 can be ordered as replacements.

560

Screw #10-32 x .312 Pan Phillips

The 560 screw is used to attach a backplate to the inside of an enclosure.

6832

Enclosure Filter with 60 Micron Pore Size

One 6832 filter may be installed in one of the small compression fittings (cable entry seals) in the enclosure to allow air pressure to equalize between the inside and outside of the enclosure. As such, the filter is used only when the cable entry seals option is selected for the enclosure (item 6447). The filter is typically used when a barometric pressure sensor (or, in some cases, the cable termination of a vented submersible pressure transducer) will be located inside the enclosure. The filter has a 60 micron pore size.

6650

Enclosure Ground Wire, 36 in.

This 36 in.ground wire and lug connector can be purchased to replace a ground wire and lug connector that has been lost or damaged.

3890

Silicone O-Ring

The 3890 is a silicone O-ring used. Customers will periodically need to replace worn-out O-rings.

6688

Plug for Cable Entry Connector

The 6688 is the plug that fits inside the 31363 Cable Entry Seal when there is not a cable running through it. The 6688 can be ordered to replace a lost plug.