Resource Center

SC-CPI OS

Software applications, data logger operating systems, firmware, and drivers for Campbell Scientific products

SC-CPI OS

v04

Execution of this download installs the SC-CPI Operating System on your computer for upload to the SC-CPI device with Device Configuration Utility.

Note: The SC-CPI OS V.02 or greater is required to use the CDM-VW300/305 with the CR3000/1000/800 datalogger that is using OS 28 or higher. The CDM-VW300/305 Operating System will also need to be upgraded to CDM-VW300/305 OS V.02. If using a CR3000/1000/800 datalogger with an older OS, an operating system upgrade to the datalogger will be required.

Revision History

v04October 10, 2016

Improved so when advancing in sequential mode, reset the tx_count synchronizationcounter between sc-cpi and logger to avoid out of sync. This was causingmeasurements outside of scan/nextscan to not be accepted because the synccounter was getting reset at the start of scan. In sequential mode there may not be astart of scan so the counters must get re-sync’d with each sequential measurement.

v03April 27, 2016

Added support for the CDM-A108 and CDM-A116. If using a CR3000/1000/800 datalogger, an operating system upgrade to OS 29 will also be required. Note: This SC-CPI operating system is not compatible with beta CDM-A108 or CDM-A116 OSs. Make sure the CDMs are running operating system version 1.0.

v02March 5, 2015

Fix the CPI configure command to use CAN ID 1. The CPI specification says that configuration messages should be sent on ID 1. The CDM-VW300 and SC-CPI were using 0. This issue was caught when the CDM-A108 configure command was implemented.