EasyFlux DL for CR6CP

Corrected a compile error for the CPEC306.

Corrected wrong units used for LE flux.

CO2 and H2O in a mole fraction in wet air was added to Flux_AmeriFlux_format and CO2 mixing ratio and H2O mixing ratio were moved to Flux_CSFormat.

Add the compatibility of pumps for two models.

Revise UPWND_DIST_INTRST to FETCH_INTRST and FTPRNT_DIST_INTRST to FP_FETCH_INTRST

Revised UPWND_DIST_INTRST to FETCH_INTRST and FTPRNT_DIST_INTRST to FP_FETCH_INTRST.

Added CSAT3AH compile switch.

Added HygroVUE10 compile switch.

EE181 and HC2S3 compile switch removed.

Update to output message when zero/span coefficient is out of plausible range.

Update diagnostic table to match open-path EasyFlux code.

Position qualifiers for multiple sensors updated to match H_V_R naming convention.

CS616 and NRLITE compile switches removed.

CPEC300 compile switch removed.

SOIL_HT_FLUX is no longer a constant.

Net radiometer power control added for low-power protection.

Heater control for SN500SS fixed and is now properly working.

VOLT naming convention added for CPI expansion modules.

Revised as a universal program for CSI CPEC systems, being compatible with CPEC300, CPEC306, and CPEC310.

Added the supporting functionalities for heating and ventilation accessories (CNF4) for CNR4.

LI-190 and LI-200 sensor compatibility removed and replaced with CS310 and CS320. Please contact Campbell Scientific if you need code compatible with removed sensors.

The design of soil heat flux measurements was optimized. Now, this program can support three replications of HFP01/HFP01SC, CS655, and optional TCAV. The default depth for CS655 was revised to 8 cm for its measurement diameter of 16 cm. As a result, the default depth of HFP01/HFP01SC was revised to 16 cm and the distribution of four probes in one TVAV is also recommended.

Constant declarations in ConstTable are more specified for Boolean (TRUE/FALSE) and Long data types. Also for constants outside ConsTable.

SN500 4-way net radiometer sensor compatibility added.

Days of MicrSD to store more data has been more accurately estimated, which is preferred by EasyFlux_web.

Added the supporting functionalities for heating of the NR01.

Optimized the use of GPS for more accurate determination of geographic coordination data.

Prioritized EC155 power-off over EC100 reset while system voltage fluctuates down to the low threshold for the system to run.

This version corrects the compile error that the previous version had with the GPS instruction.

The time to power fans and heater is no longer recorded for both simultaneously while only one is on.

In V1.00, EC100 could be endlessly reconfigured when running at 20 Hz. This has been corrected in V1.01.

Sensor wire colors have been updated to match current color scheme for all sensors used in a CPEC system.

Updated the soil moisture corrections applied to data collected using a CS650/CS655. Temperature corrections of volumetric soil moisture values less than 5% will no longer be unnecessarily applied.