TEMP120 Ordering Information

The TEMP 120 is compatible with a wide variety of 12 V and 24 V power systems. Use the 29796 if no other power source is available. The 29796 converts 100 to 240 Vac to a regulated 24 Vdc. The 29796 comes standard with a USA/Canada plug, with an option to add a kit for international use. The cable is 5 ft long and terminates in pigtails with "+" and "-" labels.

The 35690 can be purchased as an accessory to mount the 5.08 cm (2 in.) GRANITE™ modules on a DIN-Rail instead of the standard backplate mounting.

An RJ45 cable may be needed, and several options are available. The 28899 is one option. The 28899 is a 2 ft, unshielded CAT6 network cable with RJ45 connectors. It is typically used to connect CDM devices together or to an SC-CPI. This cable is also used to connect one of our many Ethernet-capable products to an Ethernet device or network connection.

An RJ45 cable may be needed, and several options are available. The 28900 is one option. The 28900 is a 10 ft, unshielded, CAT5e network cable with RJ45 connectors. It is typically used to connect one of our many Ethernet-capable products to an Ethernet device or network connection.

An RJ45 cable may be needed, and several options are available. The 28901 is one option. The 28901 is a 50 ft, unshielded, CAT5e cable with RJ45 connectors. It is typically used to connect CDM devices together or to a data logger. This cable can also be used to connect one of our many Ethernet-capable products to an Ethernet network connection.

An RJ45 cable may be needed, and several options are available. The CAT5UCBL-L is one option. This is an RJ45 cable that is ordered to a customer-defined length. We have created this so when people are connecting CDM devices together or to a data logger, they can have a custom-length cable if they do not want one of our set-length cables, which are 6 in., 2 ft, 10 ft, or 50 ft.

The HUB-CPI may be used to connect multiple CPIs in parallel together. The HUB-CPI allows eight CPI (CAN peripheral interface) devices to be connected together in parallel. Typically, this configuration includes one data logger and up to seven CDMs (Campbell distributed modules) or sensors that use CPI.

One 29370 is needed for each CPI network. Among the items included in the 29370 kit is a roll of yellow vinyl electrical tape to distinguish Ethernet cables that use CPI protocol from similar cables used for TCP/IP.

The 8125 is needed if the TEMP 120 is not ordered with a data logger or if the screwdriver that came with the data logger has been lost. The 8125 is a small, flat-bladed screwdriver that is extremely useful for opening the guillotine terminals on our data loggers and measurement control devices.