4WPB100
4WPB100
Orderable100-Ohm, Four-Wire PRT Bridge Terminal Input Module
Overview
The 4WPB100 provides completion resistors to enable your Campbell Scientific data logger to measure 100-ohm platinum resistive thermometer s(PRT) using the half-bridge four-wire measurement method.
Technical Description
4-Wire PRT Bridge Module Schematic
(Rf=100 Ω for the 4WPB100)
4WPB100-to-Sensor Hookup
Benefits
- Provides high-accuracy completion resistor and convenient wiring for four-wire, 100-ohm PRT measurements
- Easy to install or remove
- Connects directly into data logger input terminals
- Compatible with most Campbell Scientific data loggers
Specifications
- Used With
- 100 Ω platinum resistive thermometer (PRT)
- Dimensions
- 1.5 x 1.5 x 2.7 cm
(0.6 x 0.6 x 1.0 in.) for body with prongs
- Weight
- 6 g
(0.2 oz)
Current Limiting
- Resistance
- 10 kΩ
- Tolerance
- ±5%
(@ 25°C)
- Power Rating
- 0.25 W
Completion Resistor (bulk metal foil)
- Resistance
- 100 Ω
- Tolerance
- ±0.01%
(@ 25°C)
- Maximum Temperature Coefficient
- ±0.8 ppm/°C
- Power Rating
- 0.25 W
(@ 70°C)
Similar Products
(10)CURS100
100-Ohm Current Terminal Input Module
OrderableVDIV10:1
10-to-1 Voltage Divider Terminal Input Module
OrderableVDIV2:1
2-to-1 Voltage Divider Terminal Input Module
Orderable4WFBS120
120-Ohm, Four-Wire Full-Bridge Terminal Input Module
Orderable4WFBS350
350-Ohm, Four-Wire, Full-Bridge Terminal Input Module
Orderable4WFBS1K
1-kohm, Four-Wire, Full-Bridge Terminal Input Module
Orderable4WPB1K
1-kohm, Four-Wire PRT Bridge Terminal Input Module
Orderable3WHB10K
10-kohm, Three-Wire Half-Bridge Terminal Input Module
Orderable4WHB10K
10-kohm, Four-Wire Half-Bridge Terminal Input Module
Orderable4WPB500
500-Ohm, Four-Wire PRT Bridge Terminal Input Module
Orderable
Compatibility
Data Logger Considerations
The 4WPB100 uses two adjacent differential analog inputs; the first channel requires an adjacent analog ground channel to accept the "ground prong" of the 4WPB100. Not all data logger terminal strips have this sequence on all channels, so please check your data logger's wiring panel to confirm channel assignments, especially if you plan to use multiple terminal input modules.
Newer CR10X Wiring Panels and the CR10XTCR Thermocouple Cover are deep enough to cover the data logger input channels with a terminal input module attached; older CR10TCRs are not deep enough.
Programming
When using CRBasic, the 4WPB100 is measured with the BrHalf4W Instruction followed by the PRT Instruction. When using Edlog, the 4WPB100 is measured with Instruction 9 (Full Bridge w/ Measured Compensation) followed by Instruction 16 (Temperature RTD).
Compatible Products
(5)CR6
High-Capacity Data Acquisition System
OrderableNotes—CR310
Measurement and Control Datalogger
OrderableNotes—CR350
Measurement and Control Datalogger
OrderableNotes—Granite Volt 108
8- or 16-Channel 5V Analog Input Module
OrderableNotes—Granite Volt 116
16- or 32-Channel 5V Analog Input Module
OrderableNotes—
