Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CR10x modbus

Merait Jun 14, 2016 11:38 AM

hello,

I want to connect CR10x with Labview using the Modbus.
Could I  program it directly with PC200W?Or I am supposed to use Edlog?
thank you

JDavis Jun 14, 2016 02:14 PM

The ShortCut program editor included in PC200W does not support Modbus on a CR10X. You will need to write your program with the Edlog program editor included in PC400 or Loggernet.

jra Jun 14, 2016 03:20 PM

Your CR10X also needs a special MODBUS operating system

https://www.campbellsci.com/p13619

Log in or register to post/reply in the forum.