OEM Products / 20729
20729 CR800 Datalogger for OEMs
OEM Label Options - show details
-NL -NL No OEM Label
With this option, the datalogger is shipped without a label allowing the OEM to use their own label.
-SL -SL Company S OEM Label
With this option, the datalogger will include a company label instead of the Campbell Scientific label.

Add to your Quote List

Product Details
Restockable Yes
Warranty 3 years
Compliance CE Compliance Image RoHS Compliance Image

Common Accessories

The 18622 orders extended temperature testing (-55° to +85°C) of the datalogger. Analog accuracies are derated approximately two times over published specifications.
The 18624 orders the two-page calibration certificate for the datalogger.
The 3315 is a type T thermocouple. The programming examples in the Overview Section of the datalogger manual use this thermocouple.
The 10873 connects the datalogger's RS-232 port to the serial port of a battery-powered PC. This 6-ft cable terminates in a 9-pin female connector on one end and a 9-pin male connector on the other end.
The 17394 interface cable provides a USB connector on one end and a 9-pin male RS-232 connector on the other end. The USB connector attaches to the USB port on a PC, and the RS-232 connector attaches to the RS-232 port on the CR800. Cable length is 6 feet (2 m).

Other Accessories

The 18634 is offered for customers who want a paper CR800/CR850 Operator's Manual in a 3-ring binder.

Replacement Parts

The 6554 Single 0.16-Unit Silica Desiccant Bag desiccates the inside of the CR800. Campbell Scientific suggests replacing this desiccant when the lithium battery is replaced.
The 10645 is the screw used in the ground lug.
The 13519 lithium battery powers the clock and SRAM when the primary 12 Vdc power supply is not connected.
The 3768 is shipped attached to the CR800. This green, plug-in power connector provides screw terminals for connecting the 12 V and GND wires of the datalogger's power supply. The 3768 may be purchased to replace a lost or damaged power connector.