Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.
Question/Topic Posted By Replies
Coax selection for rock-mass deformation TDR project ariklee 0
is it possible 4 strain guage and 4 tiltmeter is directly connected to CR6 data logger without using CDM A116 multiplexer rohinidhatrak 0
RS-485 Surge Protection Device ariklee 2
[CR6] Staggered scans with WXT520 censamkoh 3
RM YOUNG non moving rain gauge Model 50202 or 50203 with the CR6 CESPool 1
NL201 driver on Windows 10 capmon 2
how to force a scan to occur before period elapses Shanks.J 1
Connecting to NL201 Tommer 1
RTMCpro digits displayed trashbk 0
CELL215 coverage ariklee 2
TimeIsBetween() and negative numbers kfoley 0
SDM_IO16 NEATIVE LOGIC? kikesala 2
Can I use a 7 db Omni anntenna on an RF 451 Spread Spectrum System without exceeding the allowable Db output RonS 0
SDM-SIO1 and -SIO1A modules together rrussell 0
CR1000 Strain Gauge Limiations jakewagner 10
Viewing data on Mobile Device JHWWC 15
COM111 with CR6 - configuration question and now errors fluckste 2
modbus sensor connection CR1000x cc_user 0
Agregar columna antes de TIMESTAMP de un archivo *.dat nanopol 0
RTMC opens and then closes (4.4.2) Nightwolf 2
Thies 3D Sonic with CR6: every other record is NAN, polling not working fluckste 2
Writing a file on hard drive Ehsan 8
RTMC Pro: Expressions and predefined constants jdgile 0
CR1000X I2C Communication? Not even showing up in CRBasic Editor Waq 6
SDI-12 failed param(nmsu) 0
CR6 Uninterruptible Power Supply: Solar Panel directly to CR6 or solar charge controller fluckste 3
Calibration of old dataloggers and multiplexers shishirbt 1
RX and TX control port and com port furban 5
Writing data to CR800 vie Modbus alackey 1
Email Relay - Is Konectgds Down? Brad74 1