This product is no longer available and has been replaced by: RF401. Some accessories, replacement parts, or services may still be available.
RF400 Specifications
- Operating Frequency: 910 to 918 MHz
- Type: Frequency Hopping Spread Spectrum (FHSS) Transceiver
- I/O Data Rate: 9600 bps
- Channel Capacity: 65,000 Network Identifiers share 25 hop channels
- Frequency Hopping Patterns: Six different selectable patterns
- Frequency Control: Direct FM
- Receiver Sensitivity: -110 dBm at 10-4 bit error rate (Campbell Scientific protocols will issue retries wherever a bit error occurs)
- Interference Rejection: 70 dB at pager and cellular phone frequencies
- Transmitter Power Output: 100 mW nominal
- Antenna Connector: Reverse polarity SMA
- FCC ID: OUR9XTREAM
- Operating Temperature Range: -25° to +50°C
- Power: 9 to 16 Vdc
- Average Current Drain: < 1 mA stand-by (assuming power-saving options used),
24 mA while receiving,
< 75 mA while transmitting
- LEDs: Power on, TX, RX, diagnostics
- CS I/O Connector: 9-pin “D” Male for all needed communications lines. Newer loggers provide power to the radio on this connector. Older loggers may require optional power cable #14291
- RS-232 Connector: 9-pin “D” Female for TX, RX, CTS, ground RS-232 levels
- Power Connector: Barrel connector, center positive 12 V for use in base station configuration or with older dataloggers (newer loggers provide power to the radio on the CS I/O connector)
- Weight: 227 g (8 oz)
- Dimensions: 11.4 x 7.0 x 2.9 cm (4.9" x 2.8" x 1.2")
- Dimensions with Mounts: 12.7 x 7.0 x 2.8 cm (5.0" x 2.8" x 1.1")
Note: Allow an additional 3 in. (7.5 cm) along the longest axis for external cable connection.
|
Feedback?