CDM-A100 OS

Fixed a data buffer issue that caused delayed CPI frame errors and skipped scans.

Added optional parameter support to return V1 from CDM_BrFull6W & CDM_BrHalf4W instructions.

Optimized CPI traffic when scans don’t include data from the module.

Fixed issue introduced in v06.01 causing the CDM_ACPower instruction to return incorrect results.

Fixed scan synchronization when running CPI in SW sync mode.

Added optional parameter support to return V1 from CDM_BrFull6W & CDM_BrHalf4W instructions.

Optimized CPI traffic when scans don’t include data from the module.

Fixed issue introduced in v06.01 causing the CDM_ACPower instruction to return incorrect results.

Fixed scan synchronization when running CPI in SW sync mode.

Added OS version reporting over CPI.

Fixed CPI responses to error log requests, limiting the response to 256 characters or less.

Added support for new variable-update address.

Fixed responses to CS Surveyor while busy processing previous configurations to avoid Surveyor timeouts/error messages.

Fixed SubScan sequencing, allowing other tasks to run while sequencing waits for a subscan timer to become available.

Added compatibility checking to allow modules to substitute for another module of equal or lesser value (- Substitution only works when paired with a datalogger OS built after 2019-04-01 (CR6 V9.02+, CR1000X V03.02+))

Default module control to CPI when a module is connected to both Surveyor and a CPI network and stand-alone CAN output is disabled.

Fixed CPI bus reset by disabling processor low-power modes during fast scans.

Added direct-to-PC via USB capability.

Added support for stand-alone CAN output operation.

Added optional parameter to CDM_Resistance & CDM_Resistance3W instructions to return measured excitation current.

Added CDM_TCComp instruction.

Changed default of switched ports to 'On' when running modules in direct-to-PC & stand-alone modes.

Fixed pipeline mode CPI frame errors on a heavily-loaded CPI bus.

Fixed sequential mode CPI synchronization errors.

Added CDM_ACPower instruction.

Fixed indexing bug for slow sequence instructions executed from processing.

Fixed switched port control to return control to FPGA sequencers.

Fixed channel increment bug for voltage measurements that use autoranging and reps in a slow sequence.

Fixed startup from non-power-up reset sources.

Added CDM_Delay instruction.

Changed USB subclass to 0x02 to make driver installation optional under Windows 10.

Fixed CPI synchronization errors.

Fixed slow sequence errors including compilation, excitation, & CDM_MuxSelect issues.

Fixed subscan bug where measurement sequencing blocks while waiting for the subscan timer resource.

Fixed device type auto-detection in extreme cold temperatures.